Manual Chapter : Create a virtual server that specifies multiple IP addresses and ports

Applies To:

Show Versions Show Versions

BIG-IP LTM

  • 15.1.0, 15.0.1, 15.0.0, 14.1.2, 14.1.0
Manual Chapter

Create a virtual server that specifies multiple IP addresses and ports

You can create a virtual server that specifies a list of IP addresses and a list of service ports. Specifying a list of addresses and ports is helpful when you have ingress traffic from, or destined for, disparate IP addresses, and all of the traffic requires the same set of traffic profiles and policies to be applied to it. Depending on your use case, specifying lists of addresses and ports in a single virtual server can reduce the number of virtual servers that you need to create for a network configuration.
  1. On the Main tab, click
    Local Traffic
    Virtual Servers
    Virtual Server List
    .
  2. Click
    Create
    .
    The New Virtual Server screen opens.
  3. Type a
    Name
    for the virtual server.
    An example of a name is
    http_vs
    .
  4. For the
    Destination Address/Mask
    setting, click
    Address List
    .
    The address list you created earlier as a shared object appears in the box.
  5. For the
    Service Port
    setting, click
    Port List
    .
    The port list you created earlier as a shared object appears in the box.
  6. Configure all other virtual server settings as needed.
  7. Click
    Finished
    .
After you complete this task, the virtual server listens for any IP addresses and ports within the range of addresses and ports specified, and applies the configured profiles and policies.