Manual Chapter : Provisioning Fraud Protection Service for BIG-IP DataSafe using the Configuration utility

Applies To:

Show Versions Show Versions

BIG-IP FPS

  • 17.1.0, 17.0.0, 16.1.5, 16.1.4, 16.1.3, 16.1.2, 16.1.1, 16.1.0, 16.0.1, 16.0.0, 15.1.9, 15.1.8, 15.1.7, 15.1.6, 15.1.5, 15.1.4, 15.1.3, 15.1.2, 15.1.0
Manual Chapter

Provisioning Fraud Protection Service for BIG-IP DataSafe using the Configuration utility

You must provision Fraud Protection Service (FPS) for BIG-IP DataSafe before performing any of the other tasks for adding BIG-IP DataSafe to the BIG-IP System. You can provision FPS either from the Configuration utility in the BIG-IP system, or from the TMSH TMOS Shell command line interface. The following steps explain how to provision FPS from the Configuration utility in the BIG-IP system.
  1. On the Main tab, click
    System
    Resource Provisioning
    .
  2. Go to the Fraud Protection Service (FPS) row in the list of modules, and in the Provisioning column select the check box and select one of the options from the list:
    • Dedicated:
      Specifies that the system allocates all CPU, memory, and disk resources to one module. When you select this option, the system sets all other modules to
      None
      (Disabled).
    • Nominal:
      Specifies that, when first enabled, a module gets the least amount of resources required. Then, after all modules are enabled, the module gets additional resources from the portion of remaining resources.
    • Minimum:
      Specifies that when the module is enabled, it gets the least amount of resources required. No additional resources are ever allocated to the module.
  3. Click
    Submit
    .