Manual Chapter :
Data center 2 routing diagram and table
Applies To:
Show Versions![Show Versions](/etc/designs/pcx/techdocs/images/expandversions.gif)
BIG-IQ Centralized Management
- 8.3.0, 8.2.0, 8.1.0, 8.0.0
Data center 2 routing diagram and table
You can use this diagram and routing table as a visual aid
as you analyze the static route requirements for a typical, four-NIC, BIG-IQ deployment. For a
description of these routes, refer to To see the diagram and table for the second data center,
refer to
Data center 1 routing diagram and table
on
askf5.com
.This figure illustrates the network topology for a four subnet
deployment.
Data center 2 network topology
![](/content/dam/projects/techdocs/bigiq-8-0-0/central-mgmt/images/dc2-4-nic-subnets.png/_jcr_content/renditions/original)
This table illustrates the routing table for a four subnet
deployment.
The table uses a standard syntax to express
a static route. The route expression is comprised by three octets:
<destination
address> <decimal subnet mask> <gateway>
. In
this expression:- the first octet specifies the destination IP address used to communicate with the subnet the route needs to reach.
- The next octet specifies the network mask in decimal format for the subnet the route needs to reach.
- The last octet specifies the gateway for the subnet on which the route originates.
Data center 2 routing table
![](/content/dam/projects/techdocs/bigiq-8-0-0/central-mgmt/images/dc2-4-nic-routes.png/_jcr_content/renditions/original)