Manual Chapter :
Objects to configure for L3 outbound explicit proxy topologies
Applies To:
Show Versions
BIG-IQ Centralized Management
- 8.4.0
Objects to configure for L3 outbound explicit proxy topologies
Depending on which type of protocol you select for your L3 outbound explicit topology, the system guides you through different pages to configure corresponding required objects, as shown in the table. Be prepared with this information on-hand before you begin a topology configuration.
Protocol | Objects to configure for an L3 outbound explicit proxy topology workflow |
|---|---|
TCP | SSL Configuration → Service → Service Chain → Security Policy → Interception Rule → Egress Setting → Log Settings (SSLO RPM 6.0 and later) |
UDP | Disable L3 outbound explicit proxy when using UDP protocol |
Other | Disable L3 outbound explicit proxy when using UDP protocol |
Any | SSL Configuration → Service → Service Chain → Security Policy → Interception Rule → Egress Setting → Log Settings (SSLO RPM 6.0 and later) |
