Manual Chapter :
Objects to configure for L3 outbound transparent topologies
Applies To:
Show Versions
BIG-IQ Centralized Management
- 8.4.0
Objects to configure for L3 outbound transparent topologies
Depending on which type of protocol you select for your L3 outbound transparent topology, the system will guide you through different pages to configure corresponding required objects, as shown in the table. Be prepared, and have this information on-hand before beginning a topology configuration.
When you create or edit an L3 outbound transparent topology service, the system guides you through a sequence of pages that you use to configure the required objects. The sequence of screens depends on the protocol type you select. This table lists the objects needed for each supported protocol. Be prepared, and have this information on-hand before you start configuring the L3 outbound transparent topology.
Protocol | Objects to configure in an L3 outbound transparent topology workflow |
|---|---|
TCP | SSL Configuration→ Service → Service Chain → Security Policy → Interception Rule → Egress Setting Log → Log Settings (SSLO RPM 6.0 and later) |
UDP | Service → Service Chain → Security Policy → Interception Rule → Egress Setting → Log Settings (SSLO RPM 6.0 and later) |
Other | Interception Rule → Egress Setting → Settings (SSLO RPM 6.0 and later) |
Any | SSL Configuration → Service → Service Chain → Security Policy → Interception Rule → Egress Setting → Log Settings (SSLO RPM 6.0 and later) |
