Manual Chapter :
Port profiles overview
Applies To:
Show Versions
F5OS-A
- 1.5.0, 1.4.0, 1.3.2, 1.3.1, 1.3.0, 1.2.0, 1.1.1, 1.1.0, 1.0.1, 1.0.0
Port profiles overview
The front-panel SFP28 25G ports on F5
r5000/r10000/r12000 Series
systems support port profile functionality. Port profiles enable you to change which mode, or port speed, that port uses. SFP28 ports operate at 25G by default, and SFP+ ports operate at 10G by default. Only these configurations are available:- 2x25G - 4x10G
- Two 25G (SFP28) ports run at 25G speed, and four 10G (SFP+) ports run at 10G.
- 4x25G
- All four 25G (SFP28) ports run at 25G speed.
- 8x10G
- All eight 10G (SFP+) ports run at 10G speed. This is the default configuration.
Changing the mode for a port profile reboots the system, and then removes stale interfaces and any references to stale interfaces from your configuration. You must reconfigure any previously-configured protocols to use your modified port group.
