Manual Chapter : Configure bundling for 100GbE interfaces using tmsh

Applies To:

Show Versions Show Versions

BIG-IP DNS

  • 15.0.1, 15.0.0, 14.1.2, 14.1.0, 14.0.1, 14.0.0, 13.1.3, 13.1.1, 13.1.0, 12.1.4, 12.1.3

BIG-IP PEM

  • 15.0.1, 15.0.0, 14.1.2, 14.1.0, 14.0.1, 14.0.0, 13.1.3, 13.1.1, 13.1.0, 12.1.4, 12.1.3

BIG-IP AFM

  • 15.0.1, 15.0.0, 14.1.2, 14.1.0, 14.0.1, 14.0.0, 13.1.3, 13.1.1, 13.1.0, 12.1.4, 12.1.3

BIG-IP Analytics

  • 15.0.1, 15.0.0, 14.1.2, 14.1.0, 14.0.1, 14.0.0, 13.1.3, 13.1.1, 13.1.0, 12.1.4, 12.1.3

BIG-IP ASM

  • 15.0.1, 15.0.0, 14.1.2, 14.1.0, 14.0.1, 14.0.0, 13.1.3, 13.1.1, 13.1.0, 12.1.4, 12.1.3

BIG-IP APM

  • 15.0.1, 15.0.0, 14.1.2, 14.1.0, 14.0.1, 14.0.0, 13.1.3, 13.1.1, 13.1.0, 12.1.4, 12.1.3

BIG-IP LTM

  • 15.0.1, 15.0.0, 14.1.2, 14.1.0, 14.0.1, 14.0.0, 13.1.3, 13.1.1, 13.1.0, 12.1.4, 12.1.3
Manual Chapter

Configure bundling for 100GbE interfaces using tmsh

You can use
tmsh
to configure bundling for the 100GbE QSFP28 interfaces on the platform at either 100GbE or 40GbE speeds.
The i10010 platform does not support breaking out the 100GbE interfaces (that is, disabling bundling).
  1. Open the TMOS Shell (
    tmsh
    ).
    tmsh
  2. Change to the network module.
    net
    The system prompt updates with the module name:
    user@bigip01(Active)(/Common)(tmos.net)#
    user@bigiq01(Active)(/Common)(tmos.net)#
  3. Configure bundling for a specific interface using this syntax.
    modify interface <interface_key>
    bundle
    [
    enabled
    |
    disabled
    ]
    bundle-speed
    [
    100G
    |
    40G
    |
    not-supported
    ]
    The default value of
    bundle-speed
    is determined by the interface type. Unbundled interfaces have
    bundle-speed
    set to
    not-supported
    .