Manual Chapter :
BGP and BFD protocols on the BIG-IP system
Applies To:
Show Versions
BIG-IP LTM
- 17.1.2, 17.1.1, 17.1.0, 17.0.0, 16.1.5, 16.1.4, 16.1.3, 16.1.2, 16.1.1, 16.1.0, 16.0.1, 16.0.0, 15.1.9, 15.1.8, 15.1.7, 15.1.6, 15.1.5, 15.1.4, 15.1.3, 15.1.2, 15.1.1, 15.1.0, 15.0.1, 15.0.0, 14.1.5, 14.1.4, 14.1.3, 14.1.2, 14.1.0, 14.0.1, 14.0.0
BGP and BFD protocols on the BIG-IP system
The BIG-IP® system includes support for the following routing protocols through the use of ZebOS:
- BGP
- IS-IS
- Multicast
- OSPF
- PIM
- RIP
As an alternative to using the ZebOS Integrated Management Interface (IMI), you can configure Border Gateway Protocol (BGP)
on the BIG-IP system using
tmsh
and iControl REST. The configuration in tmsh
and iControl REST is logically similar to ZebOS. By default, configuring dynamic routing using tmsh
and iControl REST is disabled.You can also configure the BFD protocol using
tmsh
and iControl® REST.More documentation on ZebOS, tmsh, and
iControl REST
Before getting started, you might want to read more documentation on ZebOS,
tmsh
, or iControl® REST. More documentation for BIG-IP®
Advanced Routing™ Module can be found here:Documentation on
tmsh
can be found here:Documentation for iControl REST can be found here:
