Manual Chapter :
Task summary for configuring IPsec in tunnel mode using dynamic template
Applies To:
Show Versions
BIG-IP APM
- 17.5.0, 17.1.2, 17.1.1, 17.1.0
BIG-IP Link Controller
- 17.5.0, 17.1.2, 17.1.1, 17.1.0
BIG-IP LTM
- 17.5.0, 17.1.2, 17.1.1, 17.1.0
BIG-IP AFM
- 17.5.0, 17.1.2, 17.1.1, 17.1.0
BIG-IP ASM
- 17.5.0, 17.1.2, 17.1.1, 17.1.0
Task summary for configuring IPsec in tunnel mode using dynamic template
Before you begin configuring IPsec, verify that these modules, system objects, and connectivity exist on the BIG-IP in both the local and remote locations:
- BIG-IP Local Traffic Manager
- This module directs traffic securely and efficiently to the appropriate destination on a network.
- Self IP address
- Each BIG-IP must have at least one self IP address, to be used in specifying the ends of the IPsec tunnel.
- The default VLANs
- These VLANs are namedexternalandinternal.
- BIG-IP connectivity
- Verify the connectivity between the client or server and its BIG-IP device, and between each BIG-IP device and its gateway. For example, you can usepingto test this connectivity.
Following is the list of tasks to complete the configuration:
Creating configuration in above order is recommended.
