Applies To:
-
F5OS-A
2.0.0, 1.8.3, 1.8.0, 1.7.0, 1.5.0, 1.3.2, 1.3.1, 1.3.0, 1.2.0, 1.1.1, 1.1.0, 1.0.1, 1.0.0
- F5 r2000/r4000 Series models
- Platform overview
- Hardware included with the platform
- Peripheral hardware recommendations
- F5OS software on F5 rSeries
- LCD menus overview
- Main menu
- System menu
- Health menu
- Options menu
- Setup menu
- System configuration from the LCD
- View system information
- Perform a soft reboot
- Perform a network reboot
- Shut down the system
- Perform a hard reset
- Power off/on the unit
- Run LCD tests
- Enable the system locator
- Configure LCD brightness
- Configure DHCP for management addresses
- Configure management IP addresses manually
- Configure DHCP for the AOM management address
- Configure the AOM management IP address manually
- Configure the baud rate
- LCD configuration from the CLI
- Show the LCD mode from the CLI
- Configure LCD secure mode from the CLI
- Disable the LCD from the CLI
- Enable LCD standard mode from the CLI
- Platform LEDs overview
- Status LED
- Alarm LED
- Management port LED
- F5 logo ball LED
- Power 1 and Power 2 LEDs
- 250W AC power supply unit (PSU) LEDs
- 650W DC power supply LEDs
- 650W HVDC power supply LEDs
- Platform interfaces overview
- 10G RJ45 interfaces
- 25G SFP28 interfaces
- Interface duplex mode and port speed
- Management port configuration overview
- Front-panel interface configuration overview
- Port groups overview
- Network interface LED behavior
- Always-On Management overview
- Access the AOM Command Menu from the serial console
- AOM Command Menu options
- Create an AOM user
- Configure the AOM management network
- Access the AOM Command Menu using SSH
- Disable network configuration